AMSOIL EaBP By-Pass Oil Filters and Mounts (EABP)
Engine wear is caused by dirt particles larger than 5 microns. The AMSOIL EaBP By-Pass Oil Filter removes particles as small as 1/10 of a micron, virtually eliminating engine wear. AMSOIL EaBP By-Pass Oil Filters filter all the Oils in a six-quart system in about five minutes at an average engine speed equivalent to 45 mph.
The AMSOIL EaBP By-Pass Oil Filter provides the best possible filtration protection against wear, Oils degradation, rust and corrosion. Working in conjunction with the engine's full-flow Oils filter, the AMSOIL EaBP By-Pass Oil Filter operates by filtering Oils on a "partial-flow" basis. It draws approximately ten percent of the Oils at any one time and traps the extremely small, wear-causing contaminants and water that full-flow filters can't remove. The AMSOIL EaBP By-Pass Oil Filter typically filters all the Oils in the system several times an hour, so the engine continuously receives analytically clean Oil.
Note: Refer to "Product Lookup Guide" located in the top left menu for your specific application needs
Reduces Wear
Approximately 60 percent of all engine wear is caused by dirt particles in the 5 to 20 micron range. These particles can get inside the precision clearances between engine components and cause severe damage. While full-flow Oils filters generally stop contaminants no smaller than 25 to 40 microns, the AMSOIL EaBP By-Pass Oil Filter effectively stops particles smaller than one micron in size, substantially reducing engine wear.
Prevents Oils Degradation, Rust and Corrosion
Water enters motor oils as a combustion by-product or as a condensate. Water contamination of the motor oils can cause extreme engine damage. Water causes metal surface rust and corrosion, which increases friction and wear and deteriorates the close-fitting tolerances between engine components. In addition, water reacts with other Oils contaminants to form corrosive acids, which also damage metal components. The AMSOIL EaBP By-Pass Oil Filter removes water, reducing the risk of Oils degradation, engine rust and corrosion.
Extends Oils Drain Intervals
Because the AMSOIL EaBP By-Pass Oil Filter removes water and particles smaller than one micron, it significantly increases the time Oils can safely be left in the engine. In fact , engines using AMSOIL Synthetic motor oils and an AMSOIL EaBP By-Pass Oil Filter routinely show much lower rates of engine wear - even when the Oils is used for significantly longer drain intervals - than engines using conventional products and conventional Oils drain intervals. That saves motorists time and money and helps protect the environment by creating substantially less used Oils.
Dual Remote Filter System
The AMSOIL Dual Remote Oils Filtration System converts an engine's full-flow Oils filter system into a full-flow/by-pass Oils filtration system by attaching an AMSOIL Full-Flow Oils Filter and AMSOIL Spin-On By-Pass Oils Filter onto a remote mount. The Dual Remote System provides superior filtration efficiency, increased Oils capacity and improved Oils filtration accessibility.
| By-Pass Filter Photos | |||
 |  |  |  |
| BMK-11 | BMK-12 | BMK-13 | BMK-15,-16 & 17 |
| AMSOIL EaBP By-Pass Oil Filter Replacement Chart | ||||||
| Type of Unit | Stock Number | Size (Approx.) | Additional Oils Needed | Crankcase Capacity | Normal Service Life b | Applications |
| SINGLE SPIN-ON ELEMENTS (Used with BMK-11 or any DUAL REMOTE SYSTEM) | EaBP-90 | Diam. = 4.5 in. Height = 6 in. With Mnt. = 8 in. | 1 qt. | up to 9 qt. | 25,000 miles or 1 year (approximately 4 times normal drain interval) | Pleasure Vehicles, Light Trucks and Smaller Commercial Applications |
| EaBP-100 | Diam. = 4.5 in. Height = 8 in. With Mnt. = 10 in. | 1.5 qt. | up to 15 qt. | |||
| EaBP-110 | Diam. = 4.5 in. Height = 10 in. With Mnt. = 12 in. | 2 qt. | up to 21 qt. | |||
| DUAL SPIN-ON ELEMENT (Used with BMK-12 DUAL-GUARD) | (2) EaBP-90's | Diam. = 5 in. Height = 9.5 in. With Mnt. = 8 in. | 2 qt. | 15 to 18 qt. | 2 times normal Oils drain interval | Large Trucks, Construction, Farm and Industrial Equipment (minimum sump capacity = 15 qt.) |
| (2) EaBP-100's | Diam. = 5 in. Height = 9.5 in. With Mnt. = 10 in. | 3 qt. | 15 to 30 qt. | |||
| (2) EaBP-110's | Diam. = 5 in. Height = 9.5 in. With Mnt. = 12 in. | 4 qt. | 15 to 42 qt. | |||
| LARGE CANISTER BY-PASS FILTERS | EaBP-50 | Diam. = 7.5 in. Length = 10 in. | 8 qt. | 15 to 30 qt. | ||
| EaBP-75 | Diam. = 7.5 in. Length = 15 in. | 12 qt. | 15 to 42 qt. | |||
a. Filters can be used on sumps of larger capacity but then require more frequent replacement.
Full details on service life included with filter installation instructions
b. Data determined in a non-turbo gasoline engine with AMSOIL 100% Synthetic motor oils and AMSOIL Full-Flow Oils Filter.
Service life varies in other engines (turbo and diesel) and with other Oil and filters.
NOTES:
- Special adapters and hardware may be required for some installations. A universal mounting bracket is included with the kit, however, custom brackets may be required depending on your vehicle's equipment options or personal preferences in mounting locations.
- Contact us for instructions before installing on vehicles with cast aluminum Oils pans.
Note: Refer to "Product Lookup Guide" located in the top left menu for your specific application needs
